I've tried nearly very other variation I can think of. I'm unable to drag partition 1 to the destination - the pointer changes to a slashed circle.

My intended destination drive is a 120 GB SSD with no partitions. #2 is 7.96 GB 'Unformatted Logical' of which 7.96 is used. #1 is 224.92 GB 'ext Active' of which 6.02 GB is used. My source drive is a 250 GB Linux boot that shows up in Macrium Reflect 7 as an MBR disk with two partitions. Change its size on the destination as desired, then proceed with any remaining partitions.īy cliffordsimmons - 20 February 2018 5:38 PMĪfter reading this I'm still having trouble. Then start dragging your partitions down from the source to destination one at a time, working left to right, but when you get to a partition you want to shrink, drag it down to the destination, click it down there, and select 'Cloned partition properties'. In the first step of the wizard where you specify the source and destination, select your smaller SSD as the destination. In Reflect, select your source disk and click 'Clone this disk'. So I'm trying to clone a 1 tb HD to a 500 gb SSD and I can't figure out how to do it! Any help would be appreciated!!!!! The F: section (originally D was only added very recently by HP when I downloaded their checking/updating service.By cliffordsimmons - 20 February 2018 4:12 AM Using disk manager, I have tried expanding the E: drive to incorporate the unallocated last section, to no effect. I haven't tried fitting it in the laptop yet, but I suspect it should work ok as it's seemingly a perfect copy - I will certainly confirm this as you suggest. The 64GB disc is still in the laptop and the 120 I was cloning to is in a USB cradle. The first photo is of Macrium prior to the cloning, and the second photo is from disk manager in Windows afterwards. Disc 1 and 2 as shown in the first photo are disc 0 and 1 as shown in the second.

Macrium reflect cloning to smaller ssd